Volkswagen Audi Skoda Seat 1.8T AEB/AGU/AJL/ANB Plug and Play standalone ecu

    Engine Code

    Plug and Play standalone ecu for the Vw/Audi AEB and AGU (cable throttle) engines, the ecu will plug straight into the original harness and doesn't require any further wiring to get the engine running.

    There is a 6 pin connector on the back of the ecu for extra inputs/outputs.
    This ecu will control the IDLE by ignition advance (similar to what recent cars do), doesn't use the original idle motor like the original ecu.
    Supplied with a basemap.
    For VAG 1.8T engines with cable throttle and Motronic M3.8.2/4/5 not for ME7.5 or electronic throttle engines, if you have a vehicle with ME7.1 or ME7.5 encu please click HERE
    Most common engine codes: AGU, AEB, AJL,ANB
    This ecu is for NON CAN-BUS vehicles only, and doesn't control automatic gearboxes or CAN-BUS dashboards from cars after 99/2000, this will require a simple can bus module that we can include on the ecu but please get in touch with us.
    Technical details.
    • 400kpa map sensor
    • Boost control
    • 16x16 ignition/fuel tables
    • Several correction tables(Dwell, IAT, cold advance etc etc)
    • Launch control (uses original clutch sensor)
    • Flat gear shift (uses original clutch sensor)
    • Full Sequential possible (only for 1 window CAM sensor)
    • Acceleration Enrichment by TPS or MAP
    • Nitrous Control
    • VSS -- (possible, not included by default)
    • Thermo Fan Control
    • Staged Injection
    • Sequential Fuel Trim
    • 0-5v input for wideband controllers
    Uses tunerstudio for tuning (it is not megasquirt based)!
    Any further questions just send us a message

    Specific References